-
2020/03
Operation process and video of rolling machine
Daily operation specification of the rolling machine: when the operator uses the rolling machine, each shift must check and clean the machine tool, and do a good job in daily maintenance to achieve tidiness, cleanness, lubrication and safety...
View details -
2020/03
Operation process and video of hoop bending machine
Operation process of full-automatic numerical control steel bar bending machine: first, check whether the performance of steel bar bending machine is excellent, and whether the operation platform and the counter top of steel bar bending machine are maintained at the same level...
View details -
2020/03
Operation process video of reducing mill
Usage and precautions of the reducer: 1. Due to the condensation on the contactor due to the change of humidity, measures shall be taken to prevent the short circuit between the contactor phases, and at the same time, the dirt on the pole surface of the iron core shall be cleaned...
View details -
2020/03
Operation video and operation flow of three-axis rolling machine
The operation process of the new automatic three-axis thread rolling machine is as follows: 1. Connect the switch power of the thread rolling machine, open the cooling circulating water gate valve, press and hold the forward rotation start button, and then you can rotate the rocker...
View details -
2020/03
Operation specification and video of spline tooth rolling machine
Before the operation of the gear hobbing machine, the oil tanks are filled with designated oil; check the fastening screws, whether the protective cover is loose or not; if there is loose, tighten it; check the hydraulic setting pressure, set the pressure in the pneumatic circuit, and mix the spray lubrication pressure...
View details -
2020/03
Operation video and usage of spline rolling mill
The usage of spline rolling mill: 1. Radial incremental rolling is grade O6 ~ 7, the maximum modulus of 30 degree pressure angle is 1.5mm, and the maximum modulus of 20 degree pressure angle is 1mm...
View details -
2020/03
Operation process and video of wire drawing machine
Safety operation procedures for wire drawing machine: 1. Requirements for work: 1. Operators must have wire drawing machine operation qualification certificate, and it is strictly prohibited to operate on the machine without certificate....
View details
- 共 1页7条记录
